Page 2 of 2
Posted: Sun Dec 05, 2004 2:49 am
by pow
I thought I was doing that by using EQ instead of IN on the onces I could find for etpro. Punkbuster reports errors on every cvar loaded with EQ in its syntax. How can I check if the etpro system did pick em up? Or even better how can I get all of them (not sure which are supported by etpro and which are punkbuster only) to be used by etpro?
Regards
Posted: Sun Dec 05, 2004 6:27 am
by =FF=im2good4u
as a client do /b_cvarlist it will show u a list
Posted: Sun Dec 05, 2004 7:11 am
by pow
Damn, I guess still not completly good:
As said during start up I get errors from pb about the cvar lines with EQ instead of IN. That's normal I guess, pb isn't suposed to use em. When I connect as a client and type /b_cvarlist nothing shows up except for [. Are the cvars for etpro supposed to just go in any .cfg started at server start or is there a specific location to use?
Pfff, harder then I thought this server stuff
Posted: Sat Dec 18, 2004 12:52 am
by pow
You stupid idiot: the lines shouldn't include pb since it's not a punkbuster cvar....all works fine now.