I thought I was doing that by using EQ instead of IN on the onces I could find for etpro. Punkbuster reports errors on every cvar loaded with EQ in its syntax. How can I check if the etpro system did pick em up? Or even better how can I get all of them (not sure which are supported by etpro and which are punkbuster only) to be used by etpro?
Regards
Minor problems on ETpro server
Moderators: Forum moderators, developers
- =FF=im2good4u
- Posts: 3821
- Joined: Wed Feb 05, 2003 7:30 am
- Location: The Netherlands, HOLLAND
- Contact:
as a client do /b_cvarlist it will show u a list
![Image](http://home.zonnet.nl/westhof99/2good2.gif)
Damn, I guess still not completly good:
As said during start up I get errors from pb about the cvar lines with EQ instead of IN. That's normal I guess, pb isn't suposed to use em. When I connect as a client and type /b_cvarlist nothing shows up except for [. Are the cvars for etpro supposed to just go in any .cfg started at server start or is there a specific location to use?
Pfff, harder then I thought this server stuff![Wink ;)](./images/smilies/icon_wink.gif)
As said during start up I get errors from pb about the cvar lines with EQ instead of IN. That's normal I guess, pb isn't suposed to use em. When I connect as a client and type /b_cvarlist nothing shows up except for [. Are the cvars for etpro supposed to just go in any .cfg started at server start or is there a specific location to use?
Pfff, harder then I thought this server stuff
![Wink ;)](./images/smilies/icon_wink.gif)