I thought I was doing that by using EQ instead of IN on the onces I could find for etpro. Punkbuster reports errors on every cvar loaded with EQ in its syntax. How can I check if the etpro system did pick em up? Or even better how can I get all of them (not sure which are supported by etpro and which are punkbuster only) to be used by etpro?
Regards
Minor problems on ETpro server
Moderators: Forum moderators, developers
- =FF=im2good4u
- Posts: 3821
- Joined: Wed Feb 05, 2003 7:30 am
- Location: The Netherlands, HOLLAND
- Contact:
as a client do /b_cvarlist it will show u a list
<a href="http://bunnyherolabs.com/adopt/showpet. ... dQ=="><img src="http://petimage.bunnyherolabs.com/adopt ... Q0dQ==.png" width="80" height="100" border="0"></a>
Damn, I guess still not completly good:
As said during start up I get errors from pb about the cvar lines with EQ instead of IN. That's normal I guess, pb isn't suposed to use em. When I connect as a client and type /b_cvarlist nothing shows up except for [. Are the cvars for etpro supposed to just go in any .cfg started at server start or is there a specific location to use?
Pfff, harder then I thought this server stuff
As said during start up I get errors from pb about the cvar lines with EQ instead of IN. That's normal I guess, pb isn't suposed to use em. When I connect as a client and type /b_cvarlist nothing shows up except for [. Are the cvars for etpro supposed to just go in any .cfg started at server start or is there a specific location to use?
Pfff, harder then I thought this server stuff